11. Lenses and Lens holder
11.12 Replacement of the Inner Dust Rubber
This procedure assumes that the Lens Holder is removed from the projector.
C
AUTION
Necessary tools
•
13 mm nut driver or open-end wrench
•
5.5 mm nut driver or box-end wrench
•
PH1 Phillips screwdriver
Necessary parts
•
Lens holder cover
•
Dust rubber frame
•
Inner dust rubber
•
6 M3 hex nuts
How to replace the Inner Dust Rubber
1. Remove the front plate from the Lens Holder. Use a 13 mm nut driver to loosen the four big nuts (reference 2 image 11-37) as
illustrated. Turn the front plate away to see the Lens Holder cover.
Caution:
Do not loose the three large springs of the Scheimpflug adjustment mechanism.
2
Image 11-37
2. Remove the Lens Holder cover. Use a PH1 Phillips screwdriver to loosen the seven screws (reference 3 image 11-38) as illus-
trated. By doing this, you will also release the ground cable (reference 4).
204
:
Be careful as not to damage the new inner dust rubber while executing this procedure.
R5905043 DP2K-12C/11CX 19/02/2018