3
4
Image 11-32
3. Place the rubber (reference 7 image 11-33) over the pins of the new cover. Carefully place the dust rubber frame (reference 6)
over the top of the dust rubber and over the pins of the new cover. Then use a 5.5 mm nut driver to tighten the dust rubber and
frame with six hex nuts (reference 5).
6
5
Image 11-33
4. Install the new Lens Holder Cover assembly onto the front plate. Use a Phillips PH1 screwdriver to tighten the seven original
screws (reference 3). Make sure you tighten the earth wire (reference 4) back to its original place.
R5905043 DP2K-12C/11CX 19/02/2018
7
11. Lenses and Lens holder
201