Barco DP2K-12C Service Manual page 120

6. Lamps and lamp houses
Image 6-35
4. Reinstall the UV blocker assembly as illustrated. Make sure that the xenon lamp is properly supported by the lamp supporting
mechanism in the centre of the UV blocker. Use the opening at the side of the lamp house to guide the supporting pin of the
xenon lamp into the anode supporting mechanism.
Image 6-36
5. Secure the UV blocker by fastening the four retaining thumbscrews as illustrated.
Note: Please ensure that the retaining thumb screws turning wires are flash with the cover or interference will occur while
inserting the lamp house into the projector.
Image 6-37
6. Reinstall the side cover of the lamp house as illustrated.
Note: Please ensure that the retaining thumb screws turning wires are flash with the cover or interference will occur while
inserting the lamp house into the projector.
116
3
R5905043 DP2K-12C/11CX 19/02/2018