Replacement Of The Status Light - Barco DP2K-12C Service Manual

12. Card Cage

12.17 Replacement of the Status Light

To access the Status Light board the rear cover of the projector has to be removed. This procedure assumes
that the rear cover is already removed.
Necessary tools
2,5 mm Allen wrench.
How to replace the Status Light from the projector?
1. Remove the two indicated screws (reference 1) of the Status Light board. As a result the board will come loose but remains
connected via the wire unit.
2. Disconnect the wire unit (reference 2) of the Status Light board.
1
Image 12-63
3. Connect a new Status Light board with the wire unit.
4. Fasten the new Status Light board with two screws. Use a 2,5 mm Allen wrench.
246
2
R5905043 DP2K-12C/11CX 19/02/2018