Focusing The Camera - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 15 First-Time Setup

Focusing the Camera

To focus the cameras using the large and small targets, complete the following steps:
Step 1 Place the small target on the center of the table, in front of the center camera.
Arrange the large target five feet (152 cm) behind the small target.
Step 2
Tip Use a chair to prop up the large target.
Figure 15-10 Arranging the Small and Large Targets
In the Cisco TelePresence Administrative GUI, click Setup, then click Show Focus Target.
Step 3
Adjust the small target so that the red box encloses the upper patterns on the large target and the green
Step 4
box encloses the patterns on the small target.
Figure 15-11 Positioning the Small and Large Targets
Large
target
Small
target
Red and green
horizontal bars
OL-27038-01
5 ft
Large target
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
10 ft
Small target
Setting Up CTS Components
Red
rectangle
Green
rectangle
15-17