Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 220

Assembling the Second Row Table
Measure the distance between the first and second row table assemblies and adjust the distance as
Step 16
required.
Make sure that the table legs are vertically level. If required, loosen the screws and adjust the vertical
Note
level of the table legs, then retighten them.
Note You can place furniture sliders (flat plastic pieces) under the second row table legs to facilitate moving
of the table assembly.
Figure 12-9 Measuring the Distance Between the First and Second Row Table Assemblies
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
12-10
Chapter 12 Building the Second Row Table (TX9200 Systems Only)
OL-27038-01