Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 118

Install the remaining frames onto the U channels by completing the following steps:
Step 21
a.
b.
Caution Make sure that the locating dowels on the sides of the panels meet with the holes on the adjoining pane.
Failure to line up the hole and the dowel can result in a broken dowel.
c.
Note
d.
Note
Key Part Description
1 Wall frame, center
2 Wall frame, center left
3 Wall frame, center right
4 Wall frame, far left
5 Wall frame, far right
6 Cam lock
7
Locating dowel
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
6-26
Place the frame on the U channel.
Gently press the frames together.
Use the cam locks to fully join the panels together.
Rotate the cam locks in the direction of the arrow that is stamped on the wall frame.
The cam locks for the top and bottom parts of the wall rotate in different directions; see
Figure 6-26 for an example.
Level the wall frames by using the leveling feet inside the wall frames.
These feet are shown in Figure
Make sure that all leveling feet touch the lower channel during the leveling process.
Part/Kit Number
700-36933-xx
Kit #69-2292-xx
700-36934-xx
Kit #69-2292-xx
700-37862-xx
Kit #69-2292-xx
700-36931-xx
Kit #69-2292-xx
700-36932-xx
Kit #69-2292-xx
N/A
N/A
Chapter 6 Installing the Free-Standing Reflector Wall Structure
6-21.
Qty Ctn
1 43-B
1 43-B
1 43-B
1 43-B
1 43-B
1
1
Notes
Part of wall frame
Part of wall frame
OL-27038-01