Table of Contents
Advertisement
Replacing the Left or Right Display—Part Number CTS-DISP-65-GEN4=
Replacing the Left or Right Display—Part Number
CTS-DISP-65-GEN4=
This procedure describes how to replace the display and includes the following sections:
•
•
Required Tools
A #4 phillips screwdriver is required.
Replacing the Left or Right Display
To replace a display:
Step 1
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
to the "OFF" position.
Step 2
Remove the top bezel.
See
Remove the bottom bezel.
Step 3
See
Remove the LED light fixture above the display.
Step 4
See
Disconnect the LED light plug from the panel-mount connector in the top panel
Step 5
Squeeze together the ends of the clips on the light cable connector, and remove it from the top panel.
Step 6
See
Remove two access panels behind display.
Step 7
See
Remove the top panel above the display.
Step 8
See
Step 9
Remove the rear panel behind the display.
See
Step 10
Unplug the two speaker cables that connect the speakers to the audio/video extension unit. Do not
disconnect the speaker cables connecting the two speakers.
Step 11
Remove the top mounting bezel bracket above the display.
See
Step 12
Remove the bottom mounting bezel bracket below the display.
See
Remove side bezel bracket.
Step 13
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-10
Required Tools, page 17-10
Replacing the Left or Right Display, page 17-10
Figure 15-13
for more information.
Figure 14-14
for more information.
Figure 14-12
for more information.
Figure 14-11
for more information.
Figure 15-16
for more information.
Figure 14-9
for more information.
Figure 14-1
for more information.
Figure 7-2
for more information.
Figure 7-4
for more information.
Chapter 17
Field-Replaceable Unit Guide
OL-27038-01
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
