Table of Contents
Advertisement
Replacing an LED Light Fixture—Part Number CTS-TX9000-LEDPK=
Replacing an LED Light Fixture—Part Number
CTS-TX9000-LEDPK=
To remove and replace an LED light fixture:
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
Step 1
to the "OFF" position.
Remove the LED light fixture.
Step 2
See
Step 3
Disconnect the LED light fixture plug from the panel-mount connector on the top panel.
See
Step 4
Connect the LED light fixture plug to the panel-mount connector on the top panel.
Step 5
Replace the LED light.
Power on the system by turning the power switches on the PDUs to the "ON" position.
Step 6
Close the bottom facade panels.
Step 7
Replacing a Speaker—Part Number CTS-TX9000-SPKR=
This section describes the steps you take to remove and replace a speaker and contains the following
topics:
•
•
Required Tools
A #3 Phillips head screwdriver is required.
Removing and Replacing a Speaker
To remove and replace a speaker, perform the following actions:
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
Step 1
to the "OFF" position.
Step 2
Remove the LED light above the speaker you want to replace.
See
Disconnect the light cable attached to the LED light above the speaker you want to replace.
Step 3
Squeeze together the ends of the clip to which the light cable connects, and remove it from the top facade
Step 4
panel.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-20
Figure 14-12
for more information.
Figure 14-11
for more information.
Required Tools, page 17-20
Removing and Replacing a Speaker, page 17-20
Figure 14-12
for more information.
Chapter 17
Field-Replaceable Unit Guide
OL-27038-01
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
