Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 153

Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Install the left, right, and center rear facade top brackets by completing the following steps:
Step 12
a.
Note
b.
c.
Note
d.
You can level the bracket using the holes in the bracket and a laser level. Raise or lower the bracket until
Tip
all holes match the laser level.
e.
Note
f.
Note
g.
Note
Key Part Description
1 Facade bracket, center rear (top)
2 Facade bracket, left rear (top)
3 Facade bracket, right rear (top)
4 Facade bracket, left, right, and center
rear (base)
OL-27038-01
Using a #2 Phillips screwdriver, begin installation of the left facade bracket (top) by partially
installing the two top screws on the left side.
These screws are shown as callout 5a in
Leave a small amount of space (just over a bracket material thickness) to allow the keyhole slot
to fit under the screw.
Place the bracket over the screw and locating pin.
Add the two screws on the bottom of the bracket.
These screws are shown as callout 5b in
Do not fully tighten the screws.
Level the bracket using the front and side brackets as a reference, then fully tighten all four screws.
Install the right bracket by completing Steps
See Figure 8-16 for more information.
Install the center bracket by completing Steps
Make sure that the slots on the left and right bracket go over the locating pin and studs on the
display assembly., The stud is shown as callout 6 in
Using 4 M5 nuts, secure the nut to the 4 M5 studs with an 8mm socket driver or open end wrench.
See Figure 8-17 for more information.
Part Number
700-37306-01
Kit #69-2323
700-37304-01
Kit #69-2323
700-37302-01
Kit #69-2323
700-37303-01
Kit #69-2323
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Figure 8-16.
Figure 8-16.
a. through d.
a. through d.
Figure 8-17
Qty Ctn Notes
1 1
1 1
1 1
3 1
and the locating pin is callout 7.
8-17