Table of Contents
Advertisement
Chapter 17
Field-Replaceable Unit Guide
Replacing the Presentation Display—Part Number
CTS-TX9K-DATADISP=
This section describes the steps you take to remove and replace the data display and contains the
following topics:
•
•
Required Tools
A #3 Phillips head screwdriver
Removing and Replacing the Presentation Display
To remove and replace the presentation display, perform the following actions:
Step 1
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
to the "OFF" position.
Disconnect the data display cables from the rear of the data display.
Step 2
Loosen the captive screws securing the data display to the data display bracket.
Step 3
See
Step 4
Remove the data display from the data display bracket.
Step 5
Remove the data display panel from the rear of the display by removing four screws.
See
Install the data display panel on to the replacement display using the four screws.
Step 6
Install the data display into the data display bracket channel.
Step 7
Secure the data display to the data display bracket with the captive screws.
Step 8
Connect the data display cables to the replacement display.
Step 9
Power on the system by turning the power switches on the PDUs to the "ON" position.
Step 10
Close the bottom facade panels.
Step 11
OL-27038-01
Required Tools, page 17-23
Removing and Replacing the Presentation Display, page 17-23
Figure 14-39
for more information.
Figure 14-37
for more information.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Replacing the Presentation Display—Part Number CTS-TX9K-DATADISP=
17-23
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
