Resetting A Display; Required Tools - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Resetting a Display

Attach the three camera cables to the camera processor. See
Step 12
connector to attach each camera cable.
Table 17-4
Camera Position
Left
Center
Right
Step 13 Replace the center rear panel.
Step 14 Replace the light cable connector.
See
Replace the center top panel.
Step 15
Reconnect the LED light plug.
Step 16
Replace the LED light fixture.
Step 17
Replace the top bezel.
Step 18
Replace the camera cover and faceplate.
Step 19
Power the system on, and close bottom right facade panel.
Step 20
Perform the camera setup procedures.
Step 21
See the
Resetting a Display
This section describes the steps you take to remove and replace the camera and contains the following
topics:
•
•

Required Tools

A #4 phillips screwdriver is required.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-8
Camera Cable Connections
Processor Connection
Figure 14-11 for more information.
"First-Time Setup" chapter for more information.
Required Tools, page 17-8
Resetting a Display, page 17-9
Chapter 17 Field-Replaceable Unit Guide
Table 17-4 for information about which
OL-27038-01