Installing The Reflector To The Wall - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Table of Contents

Advertisement

Installing the Reflector to the Wall

Installing the Reflector to the Wall
Make a note of the outlets that are on the wall on which the reflector will be mounted. See the
Step 1
of Electrical Outlets for Systems that Use a Wall-Mounted Reflector Wall" section on page 2-16
information.
Install the horizontal L brackets by completing the following tasks:
Step 2
a.
b.
c.
Use a level or a straight edge to align the top surfaces of the L brackets.
Tip
Key
Part Description
1
Horizontal L bracket, center
2
Horizontal L bracket, left
3
Horizontal L bracket, right
4
Vertical Z bracket, center
5
Vertical Z bracket, left
6
Vertical Z bracket, right
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
3-2
Mark the center of the room, or the center of the installation point for the system.
Mount the center L bracket 100mm (4 inches) above the floor and centered to center mark you
placed in Step
a.
Install the left and right L brackets to the wall, keeping all L brackets horizontally level in relation
to each other.
See
Figure 3-2
to see how the L brackets connect.
Anchors that fasten the brackets to the wall are not provided. You must purchase appropriate
fasteners depending on your type of wall (concrete, concrete block, brick, or drywall). A minimum
of 27 fasteners are required. All wall types require an anchor.
If your wall is drywall, it is recommended that the screws for each L bracket go through at least one
stud. Use anchors for the rest of the mounting points. If the screw holes do not line up with the stud,
you can drill additional holes in the L bracket to line the screw up with the stud.
Part Number
700-38159-01
Kit #69-2291-xx
700-38160-01
Kit #69-2291-xx
700-38161-01
Kit #69-2291-xx
700-38163-01
Kit #69-2390-xx
700-38164-01
Kit #69-2390-xx
700-38165-01
Kit #69-2390-xx
Chapter 3
Installing the Wall-Mounted Reflector Wall Structure
Qty
Ctn
1
43-A
CTS-TX9K-LTRF-PNL-OPT
1
43-A
CTS-TX9K-LTRF-PNL-OPT
1
43-A
CTS-TX9K-LTRF-PNL-OPT
4
43-D
1
43-D
1
43-D
"Location
for more
Notes
Installed in
Step 3
Installed in
Step 3
Installed in
Step 3
OL-27038-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cts-tx9000Telepresence system tx9200Cts-tx9200

Table of Contents