Assembling An 8-Seat Second Row For A 14-Seat Tx9200 - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Assembling an 8-Seat Second Row For a 14-Seat TX9200

Figure 13-6
There is one additional modification to make for a 10-seat system: You remove bracket "2R" from the
Note
right side of bracket 800-37777-xx and replace it with bracket "6R" from 800-37782-xx. For more
information, see the
page
Figure 13-6 Tabletop and Table Leg Part Numbers for a 10-Seat TX9200 System
Assembling an 8-Seat Second Row For a 14-Seat TX9200
To assemble a second row table with five table legs and four table sections, complete the following steps.
Step 1 Unpack each table leg.
Step 2 Set the table legs upside-down and place them in approximately the position where they are during the
final installation.
Check the label on top of the each leg to determine the placement.
Tip
With the leg still upside-down, measure the gap between the hex nut on the leveling foot and the
Step 3
structure.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
13-6
shows the sections and table legs that are removed for a 10-seat TX9200 system.
"Assembling a 4-Seat Second Row For a 10-Seat TX9200 System" section on
13-40.
Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
OL-27038-01