Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 357

Chapter 14 Completing Installation of the Main Display Structure
Systems with a free-standing reflector wall only: Install the remaining wall reflector panels by
Step 18
completing the following steps:
a.
Tip Allow approximately 100mm (4 inches) between the panels to allow hand access between the panels.
b.
c.
Use the following guidelines for adjusting gaps:
•
•
Raise or lower the panels using the leveling feet in the wall panels that are shown in
panels require further adjustment, proceed to
Key Part Description
1 Reflector panel, center
2 Reflector panel, center-left and
center-right
3 Reflector panel, far left
4 Reflector panel, far right
OL-27038-01
Gently lower the wall panels into the Z bracket channels in the wall frame.
After you install all panels, gently press the panels together until they contact each other.
Check the reflector for any gaps between the reflector panels and adjust the panels to close any gaps.
If there is a gap at the top of the panels, raise the end.
If there is a gap at the bottom of the panels, lower the end.
Part Number
700-36913-xx
Kit #69-2291
700-36911-01
Kit #69-2291
700-36906-01
Kit #69-2291
700-36910-01
Kit #69-2291
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Step 19 to adjust them.
Qty Ctn
3 43-A
2 43-A
43-A
43-A
Figure 6-21. If the
Notes
Already installed
14-43