Replacing A Table Leg Power And Ethernet Connector; Required Tools; Removing And Replacing A Table Leg Power And Ethernet Connector - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Replacing a Table Leg Power and Ethernet Connector

Remove the six microphones by removing two screws for each microphone.
Step 4
See
From the underside of the table, remove 42 screws connecting the table top to the table legs.
Step 5
Shift the table top on top of the legs to gain access to the table top section joining hardware.
Step 6
Starting at table top section F, remove the two tie plates securing table top section F to section E by
Step 7
removing six screws for each tie plate.
See
Loosen the half-moon cams securing table top sections E and F together.
Step 8
See
Remove table top section F.
Step 9
Remove the four wooden biscuits from table top section F.
Step 10
See
Repeat steps 7 through 10 for each table top section, working from section E to section A.
Step 11
Assemble and install the replacement table top as shown in the
Step 12
(TX9200 Systems Only)"
Replacing a Table Leg Power and Ethernet Connector
This section describes the steps you take to remove and replace a table leg power and Ethernet connector
and contains the following topics:
•
•

Required Tools

•
•

Removing and Replacing a Table Leg Power and Ethernet Connector

To remove and replace a table leg power and Ethernet connector, perform the following actions:
Locate the PDU into which the power and Ethernet connector you want to replace connects, and power
Step 1
it off by turning the power switch to the "OFF" position.
•
•
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-26
Figure 12-24 for more information.
Figure 12-21 for more information.
Figure 12-17 for more information.
Figure 12-17 for more information.
chapter.
Required Tools, page 17-26
Removing and Replacing a Table Leg Power and Ethernet Connector, page 17-26
A flat head screwdriver
A #3 phillips screwdriver
If you are replacing a power and Ethernet connector in a leg in the front row, remove the center upper
and lower privacy panels to gain access to the PDU. See
If you are replacing a power and Ethernet connector in the back row, determine which of the two
PDUs the power and Ethernet connector connects, and remove the privacy panel from that section
to gain access to the PDU. See
Figure 11-13
Figure 12-27 for more information.
Chapter 17 Field-Replaceable Unit Guide
"Building the Second Row Table
for more information.
OL-27038-01