Differences Between The Cts-3010 And Cts-3210 Installation And The Tx9000 And Tx9200 Systems; Tools And Equipment List - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Differences Between the CTS-3010 and CTS-3210 Installation and the TX9000 and TX9200 Systems

Differences Between the CTS-3010 and CTS-3210 Installation
and the TX9000 and TX9200 Systems
If you have installed Cisco TelePresence System 3000 series systems, be aware that you cannot use the
same procedures for building the Cisco TelePresence System TX9000 (TX9000) or Cisco TelePresence
System TX9200 (TX9200).
Be sure to follow all leveling procedures in this manual. In particular, note any variances in the floor
level and adjust the system to accommodate the variances.
An important difference is the installation of the spools to the displays. Be sure that you install the spool
tightly to the display and do not use them as a leveling device; failure to do so can cause the displays to
be out of level with the rest of the system.

Tools and Equipment List

To assemble the CTS-TX9000 and CTS-TX9200, you need the following tools and equipment:
Uncrating and Unpacking:
•
•
•
•
•
•
•
Cisco TelePresence System TX9000 Structure Assembly:
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
1-2
Chapter 1
Claw hammer or small pry bar
Large Phillips screwdriver
Long Phillips screwdriver or extension for Phillips bit
Pallet jack or hand cart (for moving component boxes to installation site)
Safety gloves
Cloth gloves (for installing the reflector panels)
Safety glasses
Cordless Driver
Phillips #0, #1, #2, #3 bits and hand tools
Extension for the Phillips bits, or a long handled screwdriver
Ratchet box wrench set with Metric sizes, or power tool Metric wrench set
(For optional seismic anchors only) 3/4" box end wrench
M6, M7, and M8 sockets and combination wrenches
Size 14 Wrench for Structure leveling feet
Size M5.5 nut driver for M3 nut (used for the power/Ethernet outlet assemblies in the table legs)
Metric Allen (hex) wrench set
Laser level with tripod (flexible type recommended)
Bubble Levels (1' and 3')
Stud Finder
Box cutter or tin snips (for removing the tabs on the center rear panel—systems with free-standing
reflector walls only)
Overview, Required Tools, Preinstallation Checks, and List of Hardware Fasteners
OL-27038-01