Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 90

Installing the Displays
Attach the 12 bezel brackets to the displays by performing the following actions:
Step 3
a.
Note
b.
c.
d.
Caution DO NOT OVERTIGHTEN THE SCREWS. Removal of these brackets is required if you need to service
or replace the display after it is mounted.
Key Part Description
1
Bezel bracket
2
M5 x 10mm screw, hex
Figure 5-4 Installing the Bezel Brackets
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
5-6
Chapter 5
Take 12 of the 24 M5 x 10mm screws and attach the screws on the outside perimeter of the display.
These screws are shown as callout 2a in
These screws might be pre-installed; if so, skip this step.
Place the bezel brackets over the screws through the keyhole slots.
Insert the remaining 12 inner screws into the display. These screws are shown as callout 2b in
Figure 5-4.
Tighten the screws snugly.
Part Number
700-37748-01
Kit #69-2318-xx
48-2058-01
Kit # 69-2360-xx
Installing the Displays and Performing Final Leveling of the Main Display Structure
Figure 5-4.
Qty Ctn
12 8
48 6
Notes
OL-27038-01