Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 201

Chapter 11 Completing Installation of the First Row Table
Attach the microphones and cable runner covers by completing the following steps:
Step 4
a.
b.
c.
d.
e.
Key Part Description
1 M4 x 10mm pan head screw
2 Left side cable runner cover
3 Right side cable runner cover
4 Microphone assembly
5
M4 x 30mm screw
6
Microphone jumper cable
7
Velcro straps
OL-27038-01
Feed the microphone cables through the holes in the table and secure each microphone with two
screws (callout 5).
Arrange the microphone so the mute button is towards the user.
Connect the microphone extension cables (callout 7) and route the microphone cables as shown,
using Velcro strips to secure the cables to the clips in the table legs.
Secure each cable runner cover (callouts 2 and 3) in place with eight screws (callout 1).
Ensure that the cables are held inside of the structure to prevent them being pinched by cosmetic
panels.
Cable routing location is important to prevent the mechanical parts interfering with the cables.
Make sure that the center microphone cable routes along the channel in the underside of the wood
and into the top of the upper truss. See
Part Number
48-2594-01
Kit #69-2352-01
700-37184-01
Kit # 69-2327-xx
700-37185-01
Kit # 69-2327-xx
74-10241-01
CTS-TX9K-MIC
N/A
N/A
52-0499-xx
Kit # 69-2403-xx
Subkit #
53-3789-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Figure 11-8 for more information.
Qty Ctn Notes
16 6
1 7
1 7
3 18, 19,
20
6 18, 19, Included with the microphone kit
20
3 18, 19, Included with the microphone kit
20
70 6 Not shown in
straps to assist with cable routing.
Figure 11-8. Use these
11-9