Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 56

Installing the Reflector to the Wall
Attach the vertical Z brackets to the L brackets and attach the Z brackets to the wall. Use the notches in
Step 3
the L brackets as a guide. See
Make sure that the Z brackets are vertically level before you attach them to the wall.
Note
Table 3-1 Measurement Descriptions
Measurement
Distance between mounting holes in
horizontal L bracket
Distance between floor and bottom hole
of vertical Z bracket
Distance between floor and middle hole
of vertical Z bracket
Distance between floor and top hole of
vertical Z bracket
Figure 3-3 Attaching the Z Brackets (1 of 2): Distance Measurements for Wall-Mounted Brackets
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
3-4
Chapter 3
Table 3-1 and Figure 3-3 for the measurements.
Distance
203.2 mm (8 inches)
165.5 mm (6 1/2 inches)
1105.3 mm (43 1/2 inches)
1930.8 mm (76 inches)
Installing the Wall-Mounted Reflector Wall Structure
OL-27038-01