Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 12

Organization of This Manual
This book includes the following chapters:
Chapter 1, "Overview, Required Tools, Preinstallation Checks, and List of Hardware Fasteners" (this chapter)
This chapter provides you with organization of the book and a list of required tools and fasteners (bolts,
and washers).
Chapter 2, "Room Requirements for the TX9000 and TX9200 Systems"
This chapter provides you with room recommendations (room colors, lighting, acoustic information) and
minimum requirements (network, lighting, heating/ventilation/air conditioning (HVAC)) required for
the room in which you install the Cisco TelePresence System TX9000.
Chapter 3, "Installing the Wall-Mounted Reflector Wall Structure"
This chapter describes the tasks you perform to install the reflector wall if the wall directly attaches to
the wall of the room.
If your reflector wall does not attach directly to the wall, see Chapter 6, "Installing the Free-Standing
Note
Reflector Wall Structure" for the instructions to install the reflector wall.
Chapter 4, "Installing And Performing Initial Leveling of the Main Display Structure"
This chapter describes the steps you complete to install the main display assembly.
Chapter 5, "Installing the Displays and Performing Final Leveling of the Main Display Structure"
This chapter describes the procedure you perform to install the displays onto the display structure.
Chapter 6, "Installing the Free-Standing Reflector Wall Structure"
This chapter describes the steps you perform to build a free-standing reflector wall (used if your reflector
wall does not attach directly to the wall of the room).
Chapter 7, "Installing the Bezel Brackets and Vertical Bezels"
This chapter describes the procedure you perform to install the bezel brackets and vertical bezels.
Chapter 8, "Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner"
This chapter describes the steps you perform to assemble the electrical components, including the
camera, into the display assembly.
Chapter 9, "Starting Installation of the First Row Table"
This chapter documents the procedure to build the table assembly.
Chapter 10, "Connecting and Routing the Cables"
This chapter describes the steps you complete to route the power and signal cables for the display
assembly.
Chapter 11, "Completing Installation of the First Row Table"
This chapter describes the final steps you perform to complete installation of the first row table.
Chapter 12, "Building the Second Row Table (TX9200 Systems Only)"
This chapter describes the steps you build the second row table for TX9200 systems.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
xii
OL-27038-01