Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 406

Replacing the Center Display—Part Number CTS-DISP-65-GEN4=
Table 17-5
Camera Position
Left
Center
Right
Step 35 Replace the center rear panel.
Replace the light cable connector.
Step 36
See Figure 14-11
Replace the center top panel.
Step 37
Reconnect the LED light plug.
Step 38
Replace the LED light fixture.
Step 39
Replace access panels.
Step 40
Replace the top bezel.
Step 41
Install bottom bezel.
Step 42
Power the system on, and close bottom facade panels.
Step 43
Perform the camera setup procedures.
Step 44
See the
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-14
Camera Cable Connections
Processor Connection
for more information.
"First-Time Setup" chapter for more information.
Chapter 17 Field-Replaceable Unit Guide
OL-27038-01