Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 141

Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Using four M4 x 16mm screws per codec, mount the codecs onto the display assembly by completing
Step 5
the following steps:
a.
b.
c.
d.
Caution You must install the codec as shown in
cause the codec to overheat, make excessive noise, and/or fail.
Note The labels that are affixed to the codecs might differ in appearance from the labels shown in
Key Part Description
1 M4 x 16mm screws
Figure 8-4 Installing the Codecs Onto the Display Assembly
OL-27038-01
Partially install the four screws.
Insert the keyhole slots in the top codec brackets past the screws.
Lower the codec onto the screws.
Secure the screws.
Part Number
48-3011-01
69-2367-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Figure 8-3. Failure to mount the codec in this orientation can
Qty
16
Figure
Ctn Notes
6
8-4.
8-5