Cts-Tx9Xx0-Tbl-Wb= (Walnut Finish); Required Tools; Removing And Replacing The Back Row Table Top - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 17 Field-Replaceable Unit Guide
Loosen the half-moon cams securing the two table top sections together.
Step 12
Remove the outer table top section.
Step 13
Note
Remove the four wooden biscuits from table top section you removed.
Step 14
See
Repeat steps 11 through 14 for the other outer table top section.
Step 15
Remove the center table top section.
Step 16
Assemble and install the replacement table top as shown in the
Step 17
Table"
Replacing the Back Row Table Top—Part Number
CTS-TX9XX0-TBL-MB= (Maple Finish) or CTS-TX9XX0-TBL-WB=
(Walnut Finish)
This section describes the steps you take to remove and replace a back row table top piece and contains
the following topics:
•
•

Required Tools

•
•
•

Removing and Replacing the Back Row Table Top

To remove and replace the back row table top, perform the following actions:
Remove the microphone cable covers from the underside of each back row table top section.
Step 1
See
Remove the six privacy panels.
Step 2
See
Disconnect the microphone extension cables from the six microphones.
Step 3
See
OL-27038-01
Replacing the Back Row Table Top—Part Number CTS-TX9XX0-TBL-MB= (Maple Finish) or CTS-TX9XX0-TBL-WB=
Do not put the weight of any table section on the outer legs. Ensure that the all table sections are
partially supported by the center leg structure.
Figure 11-2 for more information.
chapter.
Required Tools, page 17-25
Removing and Replacing the Back Row Table Top, page 17-25
A #3 Phillips head screwdriver
A flat head screwdriver
A level (laser level recommended)
Figure 12-28 for more information.
Figure 12-27 for more information.
Figure 12-25 for more information.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
"Completing Installation of the First Row
17-25