Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 115

Chapter 6 Installing the Free-Standing Reflector Wall Structure
Level the center wall frame, both horizontally and vertically. To adjust the level of the frame, complete
Step 18
the following steps:
a.
b.
c.
Key Part Description
1 Display stand support arms
2 Display stand, center
3 Center reflector wall and reflector
4
Leveling foot
5
Shelf edge
Figure 6-21 Leveling the Center Wall Frame
OL-27038-01
Remove the center wall reflector panel by gently lifting it out of the Z bracket channels in the wall
frame.
You can rest the panel on the support arms during the leveling process.
Using a laser level (preferred) or a bubble level, level the frame so that the wooden cross-arms are
level.
Use the leveling screw located in the lower part of the wall frame to level the frame.
Replace the center wall reflector panel by gently lowering it into the Z bracket channels in the wall
frame.
Part Number
800-37499-01
Kit #69-2340-xx
800-37616-xx
Kit #69-2323-xx
N/A
N/A
N/A
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Qty Ctn Notes
2 43-C-1 and
43-C-2
1 1
1
1 Part of reflector wall
1 Place the level against this
edge.
6-23