Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 138

Make a note of the electronic equipment that you install in the first part of this chapter.
Step 1
describes the electronic equipment locations and
Table 8-1
Key Left Side
Codecs (2)
1
Codec power supplies (2)
2
Audio/video extension unit power supply
(1)
See Figure 8-5
Note
3 illustration of this component.
Light Control Unit (LCU) power supply (2)
Note See Figure 8-5
4 illustration of this component.
Camera power supply (not shown)
5
Figure 8-1 Electronic Equipment Installation Locations
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
8-2
Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Electronic Equipment Location
Right Side
Codecs (2)
Codec power supplies (2)
for a more detailed
for a more detailed
Installs to the right of the center
notch in the top edge of the
electronic equipment bracket
Figure 8-1 shows the electronic equipment locations.
Center-Left Side
Light Control Unit
Note See
the location of this
unit.
Audio/Video Extension Unit
Note See
the location of this
unit.
Camera power supply (not
shown)
Table 8-1
Figure 8-7 for
Figure 8-7 for
OL-27038-01