Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 326

Install the LED lights into the light bar on the panels by completing the following steps:
Step 7
a.
b.
Note
c.
Key Part Description
1 LED lights, left and right (4 feet)
2 LED lights, center (2 feet)
Figure 14-11 Installing the LED Lights (1 of 3)—Connector Location
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
14-12
Snap the Molex connector from the LED light into the connector shown in
Place one end of the LED light into its recess in the top cover, then snap it down into place. See
Figure 14-12 and Figure 14-13
Press on the clip tabs as needed to open the clips during installation. Use finger force only.
Repeat Step a. through Step
Part Number
74-10337-01
Kit #74-10342-xx
74-10336-01
Kit #74-10342-xx
Chapter 14
for more information.
b. for the other three lights.
Qty Ctn
2 21
2 21
Completing Installation of the Main Display Structure
Figure
Notes
14-11.
OL-27038-01