Table of Contents
Advertisement
Replacing a Microphone—Part Number CTS-TX9K-MIC=
Power on the system by turning the power switches on the PDUs to the "ON" position.
Step 6
Close the bottom facade panels.
Step 7
Replacing a Microphone—Part Number CTS-TX9K-MIC=
This section describes the steps you take to remove and replace a microphone and contains the following
topics:
•
•
Required Tools
A #3 Phillips head screwdriver is required.
Removing and Replacing a Microphone
To remove and replace a microphone, perform the following actions:
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
Step 1
to the "OFF" position.
Step 2
Remove one of the following, depending on which microphone you are replacing:
•
•
•
Disconnect the microphone extension cable from the microphone you want to replace.
Step 3
Remove two screws securing the microphone to the table top, and remove the microphone.
Step 4
Install the replacement microphone using the two screws.
Step 5
Connect the microphone extension cable to the replacement microphone.
Step 6
Power on the system by turning the power switches on the PDUs to the "ON" position.
Step 7
Close the bottom facade panels.
Step 8
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-22
Required Tools, page 17-22
Removing and Replacing a Microphone, page 17-22
If you are replacing the center microphone in the front row, remove the center microphone cable
cover.
See
Figure 11-14
for more information.
If you are replacing one of the outer microphones in the front row, remove the microphone cable
cover on the underside of the table section in which the microphone is installed.
See
Figure 11-8
for more information.
If you are replacing a microphone in the second row, remove the privacy panel for that section.
See
Figure 12-3
for more information.
Chapter 17
Field-Replaceable Unit Guide
OL-27038-01
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
