Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 207

Chapter 11 Completing Installation of the First Row Table
Route the Cisco Touch cable and complete the assembly of the cable bridge by performing the following
Step 8
tasks:
a.
b.
c.
Note
Key Part Description
1 Cisco Touch cable (5 meter Ethernet
cable)
2 Inner cable bridge cap
3 Cable bridge
4 M4 x 10mm screw
Figure 11-12 Installing the Cable Bridge Cap (2 of 2)—Cable Bridge Cap and Cisco Touch Cable
OL-27038-01
Pull the cable for the Touch device out until there is eight feet (2.5 meter) of slack.
Place the Touch device cable between the inner cable bridge cap you assembled in
cable bridge.
Rotate the cable bridge into position and secure the bridge to the table assembly using two screws
(callout 4).
Make sure that the presentation cable and the Touch cable are in separate routing paths.
Part Number
700-37739-01
Kit # 69-2332-xx
700-27738-01
Kit #69-2332-xx
48-2594-01
Kit #69-2352-01
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Qty Ctn Notes
1 Already installed
1 2
1 2
2 6
Step 7 and the
11-15