Steps To Perform Prior To The Assembly - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Steps to Perform Prior to the Assembly

Steps to Perform Prior to the Assembly
Unpack each table leg and measure the gap between the hex nut on the leveling foot and the structure.
Step 1
If required, adjust the nut until the distance between the hex nut and the structure is 16mm (5/8 inch).
Step 2
Figure 9-1 Adjusting the Leveling Feet on the Table Legs
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
9-2
Chapter 9 Starting Installation of the First Row Table
OL-27038-01