Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 281

Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
Complete cabling of the second row and attach the outer leg panel and electrical egress box by
Step 29
completing the following steps:
a.
b.
c.
Use electrical egress box 800-37783-xx if floor has a trench; use electrical egress box 800-37909-xx if
Note
cables will run above the ground.
d.
e.
Key Part Description
1 Velcro straps
2 Electrical egress box for floors with
trench
3 M4 x 12mm screw
4
Outer leg panel
5
Electrical egress box with mouse hole
(for floors with above-ground wiring
egress)
OL-27038-01
Run all the cables into table leg 800-37778-xx.
Use velcro straps (callout 1) to secure the cables.
Run the cables into the floor opening; then, attach the electrical egress box assembly (callout 2 or
callout 5) using 2x screw (callout 3).
Ensure that all cables are neatly routed inside of the table leg, as the cables could prevent assembly
of the outer leg panel.
Attach the outer leg panel (callout 4).
Part Number
52-0499-xx
Kit # 69-2403-xx
Subkit # 53-3789-xx
800-37783-xx
Kit # 69-2314-xx
48-2426-xx
Kit #69-2358-xx
Subkit #53-3789-xx
700-37281-xx
Kit #800-37778-xx
Subkit # 69-2314-xx
800-37909-xx
Kit # 69-2314-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Assembling an 8-Seat Second Row For a 14-Seat TX9200
Qty Ctn Notes
70 6 There are 70 straps in the
kit.
1 51
2 6
1 51
1 51
13-35