Table of Contents
Advertisement
Chapter 10
Connecting and Routing the Cables
Tip
Use the Velcro tie wraps to coil and bundle excess cable.
Note
Be sure to keep the types of cable separate. You can join cables of different types as long as the cables
are less than 3 feet (1 meter) long.
Wiring Diagrams for CTS TX9000 and TX9200 Systems
Figure 10-16
Note
Click
Click
When connecting the cable that connects the TS1 codec to the audio/video expansion unit (labeled D1
Note
on the wiring diagram), be sure to connect to the port labeled "AUX" on the audio/video expansion unit.
Using the Correct DVI Port When Connecting the Display Cables
When you connect the DVI cables to the display, be sure to plug the cable into the white port labeled
"DVI". This is the connection on the left in
port labeled "AUX" or the display goes into a "deep sleep" mode and will not become active.
Figure 10-15
DVI and Aux Ports on the Display
OL-27038-01
and
Figure 10-17
show the wiring diagram for the TX9000 and TX9200 systems.
here
for a high-resolution PDF version of the wiring diagram.
here
for a printable version that is two pages and fits on 8 1/2 x 11-inch paper.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Wiring Diagrams for CTS TX9000 and TX9200 Systems
Figure
10-15. Do not plug the DVI cable into the orange
10-17
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
