Table of Contents
Advertisement
Chapter 17
Field-Replaceable Unit Guide
Replacing the Camera—Part Number CTS-TX9K-CAMCLSTR=
This section describes the steps you take to remove and replace the camera and contains the following
topics:
•
•
Required Tools
A 3mm allen wrench is required.
Removing and Replacing the Camera
To remove the existing camera and replace it with a new camera, perform the following actions:
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
Step 1
to the "OFF" position.
Remove the camera cover and faceplate.
Step 2
See
Step 3
Remove the top bezel.
See
Step 4
Remove the two center LED light fixtures.
See
Disconnect the LED light plug from the panel-mount connector in the center top panel
Step 5
Squeeze together the ends of the clips on the light cable connector, and remove it from the center top
Step 6
panel.
See
Remove the center top panel.
Step 7
See
Remove the center rear panel.
Step 8
See
Unplug the camera cables from the camera processor.
Step 9
Remove the camera cluster.
Step 10
See
Install the replacement camera cluster.
Step 11
OL-27038-01
Required Tools, page 17-7
Removing and Replacing the Camera, page 17-7
Figure 15-15
for more information.
Figure 15-13
for more information.
Figure 14-12
for more information.
Figure 14-11
for more information.
Figure 14-10
for more information.
Figure 14-5
for more information.
Figure 8-19
for more information.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Replacing the Camera—Part Number CTS-TX9K-CAMCLSTR=
17-7
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
