Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 140

Install the top and bottom brackets for the codec by placing the brackets on the codec and tightening the
Step 4
captive screws on the brackets with a #2 screwdriver or driver bit.
Note the orientation of the brackets in relation to the codecs as shown in
Mount the brackets with the keyhole mount on the top of the codec and the slotted mount on the bottom.
Note The numbers in
Key Part Description
1 Codec bracket, top
2 Codec bracket, bottom
3 Captive screws
Figure 8-3 Installing the Codec Brackets Onto the Codecs
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
8-4
Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Figure 8-3 are upside down.
Part Number
700-37129-01
Kit #69-2323-xx
700-37128-01
Kit #69-2323-xx
N/A
Qty Ctn Notes
4 1 This bracket points up after you install the codecs
vertically.
4 1 This bracket points down after you install the codecs
vertically.
16 Part of the codec brackets
Figure 8-3 and Figure 8-4.
OL-27038-01