Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 200

Secure the table sections to the table legs by completing the following steps:
Step 3
a.
b.
Note
c.
Caution USE THE CORRECT M8 x 16mm SCREWS FOR THIS STEP.
shoulder washers. Using incorrect, longer screws can cause leveling problems with the table sections.
Key Part Description
1
Cable Runner, upper sections
2 M4 x 10mm screw
3
M8 x 16mm screw
Figure 11-7 Attaching the Table Sections to the Table Legs
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
11-8
Slide the fully assembled table top into position.
Secure the table top to the legs with 26 screws (callout 2)
Start installing the two screws nearest the display structure for the center legs; then, install the
same two screws for each of the outer legs. Then, attach and tighten all screws.
Secure the upper sections of the cable runner to the table with 16 M4 x 10mm screws (callout 1 in
Figure 11-7).
Part Number
700-37028 (right),
700-37740 (left)
Kit #69-2332
48-2594-01
Kit #69-2352-01
48-2430-01
Kit # 53-3789-xx
Subkit #
69-2353-xx
Chapter 11 Completing Installation of the First Row Table
The correct screws do not have
Qty Ctn Notes
2 2
16 6
30 6
OL-27038-01