Other Devices - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Setting Up CTS Components
The Cisco TelePresence System can display information from multiple input devices during a meeting;
Note
if multiple input devices are sending information, the display shows the input from the last presentation
display sending information. If you do not see an input device image, try the following: for VGA devices,
unplug the device from the VGA cable, wait 5 seconds, and then plug the device back in; for document
cameras: turn the camera off, wait 5 seconds, and then restart the device.

Other Devices

Use Other Devices to check the Auxiliary Control Unit, which controls the light units surrounding the
displays, and enables the CTS to get more complete presentation display status information and restore
presentation display defaults.
•
•
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
15-28
Click Other Devices on the Hardware Setup window.
Click the Start radio button to access the Auxiliary Control Unit to begin testing. To end the test,
click Stop.
– Individual light units correspond to the five port numbers of the Auxiliary Control Unit. Click
the appropriate box to select a specific port number; Click Select All to select all ports (and all
light units) or Select None.
Click the Refresh On/Off Status button to update the on/off status of each port.
–
Click the Turn Selected Lights On/Off to test the selected light unit(s).
–
Click the Reset Auxiliary Control Unit to power cycle the Auxiliary Control Unit.
–
Chapter 15 First-Time Setup
OL-27038-01