Setting Up The Speakers - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 15 First-Time Setup
Troubleshooting Cameras
Use
Table 15-3
Problem
Camera image appears on the
wrong display.
Image not positioned correctly.
Image colors are incorrect.
No image.
No image.

Setting Up the Speakers

The speakers are set up correctly when you can hear sound clearly from each one. You can choose
whether you want to cycle through the speakers automatically or manually.
•
•
•
•
OL-27038-01
Table 15-3 to troubleshoot problems with cameras.
Troubleshooting Chart for Camera Problems
Click Speakers on the Hardware Setup window to select the speaker test.
Click Start to begin the speaker setup.
Click Cycle Through Speakers to have sound cycled automatically for 5 seconds on each speaker.
Click Manually Step Through Speakers to test sound on each speaker. Click Next Speaker to
progress to the next speaker.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Possible Cause
Cables are plugged into the
wrong connector ports.
Camera is not aligned correctly.
Video cable is only partially
connected.
Color settings are not correct.
Lens cap is in place.
Camera is not plugged in or is
plugged in incorrectly.
Camera or display is broken.
Setting Up CTS Components
Action
Check the wiring diagram that is
included with the system to
check wiring. For more
information, see Chapter 10,
"Connecting and Routing the
Cables."
Adjust and focus the camera
using the targets.
Check to see if the cord is fully
plugged in.
Re-check the camera adjustment
procedures and the display color
temperature. The procedures are
in this chapter.
Remove the lens cap.
Check power connections and
switches on each display.
Verify that the video and
Ethernet cables from each
camera are plugged into the
correct connectors on their
respective codecs.
Contact Cisco technical support
if you are certain that the cabling
is correct, power is applied, and
a display and camera test has
been run, but no image is seen on
the display.
15-23