Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 308

Assembling a 4-Seat Second Row For a 10-Seat TX9200 System
When connecting the microphone cables to the audio/video extension unit (LAEB), follow the wiring
Step 20
diagram in the
omitting the connections on the LAEB that are shown in
MIC 4, MIC 5, MIC 8, and MIC 9 in
Figure 13-48 LAEB Connections
Complete cabling of the second row and attach the outer leg panel and electrical egress box by
Step 21
completing the following steps:
a.
b.
c.
Note Use electrical egress box 800-37783-xx if floor has a trench; use electrical egress box 800-37909-xx if
cables will run above the ground.
d.
e.
Key Part Description
1
Velcro straps
2
Electrical egress box for floors with
trench
3
M4 x 12mm screw
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
13-62
"Wiring Diagrams for CTS TX9000 and TX9200 Systems" section on page
Run all the cables into table leg 800-37778-xx.
Use velcro straps (callout 1) to secure the cables.
Run the cables into the floor opening; then, attach the electrical egress box assembly (callout 2 or
callout 5) using 2x screw (callout 3).
Ensure that all cables are neatly routed inside of the table leg, as the cables could prevent assembly
of the outer leg panel.
Attach the outer leg panel (callout 4).
Part Number
52-0499-xx
Kit # 69-2403-xx
Subkit # 53-3789-xx
800-37783-xx
Kit # 69-2314-xx
48-2426-xx
Kit #69-2358-xx
Subkit #53-3789-xx
Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
Figure
Figure 10-16 and Figure 10-17.
Qty
70
1
2
13-28. The connections are denoted as
Ctn Notes
6 There are 70 straps in the
kit.
51
6
10-17,
OL-27038-01