Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 98

Attach the U channel assembly by completing the following steps:
Step 4
a.
b.
c.
d.
a.
Do not fully tighten the nuts at this time.
Note
Key Part Description
1 Center-left and center-right U Channel
2 Center attachment piece
3 Center alignment pieces
4 M5 nuts
Figure 6-6 Attaching the Center U Channels to the Center Floor Plate (1 of 3)—U Channel Detail
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
6-6
Slide the center attachment pieces (callout 2 in
floor bracket.
Place the Center-left and center-right U channel (callout 1 in
attachment pieces and the center floor bracket.
Place the Center alignment pieces (callout 3 in
Attach the U channel attachment pieces to the center floor plate using four M5 nuts.
Attach the center-left and center-right U channels to the left and right floor plates, and the U channel
attachment pieces, using four M5 nuts.
Part/Kit Number
700-38998-01
Kit #69-2292-xx
700-38999-01
Kit #69-2292-xx
700-39006-01
Kit #69-2292-xx
49-0747-01
Kit #69-2410
Chapter 6 Installing the Free-Standing Reflector Wall Structure
Figure 6-7 and Figure 6-8) underneath the center
Figure 6-7) on top of the center
Figure 6-7) on the two outside studs
Qty Ctn Notes
2 43-B
1 43-B
2 43-B
4 6
OL-27038-01