Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 97

Chapter 6 Installing the Free-Standing Reflector Wall Structure
Attach the left and right floor brackets to display structure by completing the following steps:
Step 3
If you have a system with a wall-mounted reflector, skip this step and proceed to
Note
a.
a.
b.
Figure 6-5
Note
Key Part Description
3 Floor bracket, left
4 Floor bracket, right
5 M6 x 16mm pan head screws
6 Acorn nut
7 Washer
Figure 6-5 Attaching the Left and Right Floor Brackets
OL-27038-01
Slide the structure so that the four studs in each bracket match the holes in the display structure.
From the rear of the system, attach two M6 x 16mm pan head screws per bracket (callout 5 in
Figure 6-5.
From the front of the system, attach four acorn nuts and washers to the four studs in each bracket.
shows the structure from the rear. Left and right are reversed.
Part/Kit Number
700-39001-01 and
700-39005-01
Kit #69-2292-xx
700-39000-01 and
700-39004-01
Kit #69-2292-xx
48-3000-01
Kit #69-2356
TBD
TBD
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Qty Ctn Notes
1 43-B
1 43-B
4 6
4 Not in illustration
4 Not in illustration
Step 4
6-5