Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 157

Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Install the left, right, and center rear facade (base) brackets by completing the following steps:
Step 13
a.
Note
a.
b.
c.
d.
e.
f.
Key Part Description
1 Facade bracket, left, right, and center
rear (base)
2 M6 x 16mm pan head screws
OL-27038-01
Install the left facade bracket (base) by partially installing the two top screws. These screws are
shown as callout 2a in Figure
Leave a small amount of space (just over a bracket material thickness) to allow the keyhole slot
to fit under the screw.
Place the bracket over the two screws.
Add, but do not fully tighten, the two remaining screws. These screws as shown as callout 2b in
Figure 8-18.
Press the bracket as far down as it will go.
Fully tighten all screws.
Install the right bracket by completing Steps
Install the center bracket by completing Steps
Part Number
700-37303-01
Kit #69-2323-xx
48-3000-01
Kit #69-2356-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
8-18.
a. through d.
a. through d.
Qty Ctn Notes
3 1
12 6
8-21