Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 206

Route the presentation cable and assemble the inner cable bridge cap to the table assembly by completing
Step 7
the following steps:
a.
b.
c.
Key Part Description
1 Presentation Cable
2 Inner cable bridge cap
3 M4 x 10mm screw
4
M4 nut
Figure 11-11 Installing the Inner Cable Bridge Cap (1 of 2)—Cable Bridge Cap and Presentation Cable
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
11-14
Route the presentation cable into the inner part of the cable bridge (the plastic funnel-shaped
assembly in the table).
Assemble the inner cable bridge cap (callout 1) to the cable bridge with four screws and nuts,
making sure that the presentation cable routes between the cable bridge and the cable bridge cap.
Pull the presentation cable out of the hole in the table until there is eight feet (2.5 meter) of slack.
Part Number
N/A
700-37739-01
Kit # 69-2332-01
48-2594-01
Kit # 69-2352-01
49-0746-01
Kit # 69-2362-01
Chapter 11 Completing Installation of the First Row Table
Qty Ctn Notes
1 Already installed
1 2
4 6
4 6
OL-27038-01