Table of Contents
Advertisement
Chapter 17
Field-Replaceable Unit Guide
Remove the power/Ethernet channel panels on the leg containing the power and Ethernet connector you
Step 2
want to replace.
See
Disconnect the power and Ethernet cables from the connector.
Step 3
Remove the four screws securing the power and Ethernet connector, and remove the connector.
Step 4
See
Install the replacement power and Ethernet connector using the four screws.
Step 5
Connect the power and Ethernet cables to the replacement connector.
Step 6
Reinstall the power/Ethernet channel panels.
Step 7
Power on the system by turning the power switch on the PDU to which the power and Ethernet connector
Step 8
connects to the "ON" position.
Replace the privacy panels you removed in Step 1.
Step 9
Replacing the Presentation Video Cable or the Cisco Touch
Ethernet Cable
This section describes the steps you take to remove and replace a table leg power and Ethernet connector
and contains the following topics:
•
•
Required Tools
A #3 phillips screwdriver is required.
Removing and Replacing the Presentation Video Cable or the Cisco Touch
Ethernet Cable
To remove and replace the presentation video cable or the Cisco Touch Ethernet cable, perform the
following actions:
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
Step 1
to the "OFF" position.
Remove the cable management ball from the cable you want to replace.
Step 2
Remove the center upper and lower privacy panels in the front row.
Step 3
See
Remove the outer cable bridge.
Step 4
OL-27038-01
Figure 11-1
for more information.
Figure 9-5
for more information.
Required Tools, page 17-27
Removing and Replacing the Presentation Video Cable or the Cisco Touch Ethernet Cable,
page 17-27
Figure 11-13
for more information.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Replacing the Presentation Video Cable or the Cisco Touch Ethernet Cable
17-27
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
