Setting Up The Cameras; Starting The Software Setup And Preparing The Cameras And Camera Targets - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 15 First-Time Setup

Setting Up the Cameras

The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera's focus.
This section describes the procedures you perform to set up the camera and includes the following topics:
•
•
•
•

Starting the Software Setup and Preparing the Cameras and Camera Targets

To start the software setup, complete the following steps.
Assemble the large camera target.
Step 1
When you slide the Camera target into the frame, make sure the target is centered in the frame between
the vertical lines at the top and bottom of the target.
Table 15-2 Parts List for the Camera Target
Key Part Description
1 Tabletop camera target: large
2 Tabletop camera target: small
3
Cardboard ruler
4 Vertical bar
5 Horizontal bar
6 M4 x 20 mm screws
OL-27038-01
"Starting the Software Setup and Preparing the Cameras and Camera Targets" section on page 15-9
"Adjusting the Zoom" section on page 15-12
"Focusing the Camera" section on page 15-17
"Attaching the Camera Hood Assembly, Top Bezel, and Service Panels and Aligning the Rear
Panels" section on page 15-18
Part Number
700-24323-xx
700-24320-xx
700-24321-xx
700-23961-xx
700-23960-xx
48-0654-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Qty Ctn
1
1
1
2
2
4 1
Setting Up CTS Components
Notes
15-9