Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 304

Assembling a 4-Seat Second Row For a 10-Seat TX9200 System
Secure the table sections to the table legs by completing the following steps:
Step 16
a.
b.
c.
d.
e.
USE THE CORRECT M8 x 16mm SCREWS FOR THIS STEP.
Caution
shoulder washers. Using incorrect, longer screws can cause leveling problems with the table sections.
Note Figure 13-44
10-, 14-, or 18-seat system.
Key Part Description
1
M8 x 16mm pan head screws, black
Figure 13-44 Connecting the Table Sections to the Table Legs
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
13-58
Slide the table top to line up the two holes nearest the middle table leg.
Put in two screws (shown as callout 1a in
Loosely screw in the two screws nearest the 65-inch displays for each leg.
Insert the screws farthest away from the displays (shown as callout 1b in
legs.
Fully tighten the screws you inserted in Steps
shows a second row with six sections; however, this assembly step is the same for either a
Part Number
48-2430-xx
Kit # 53-3798-xx
Subkit # 69-2353-xx
Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
Figure 13-44), but do not fully tighten them.
a. through d.
Qty
42
Figure 13-44) for all table
The correct screws do not have
Ctn Notes
47
OL-27038-01