Table of Contents
Advertisement
Chapter 2
Room Requirements for the TX9000 and TX9200 Systems
Auxiliary Display Considerations For the TX9200
The TX9200 has an LCD display below its three primary video displays. Content below the primary
video displays is difficult for participants in the second row to see. The solution to this is that both
systems include a 4-port HD video (uses HDMI connector) splitter for additional external displays as
part of the audio-video expansion unit.
This splitter enables you to add up to three additional data displays in the room so that second-row
participants can easily view shared data. It also gives you flexibility to choose the number, size, and
location of the extra displays in the room. We would recommend at least a 50 inch display when using
one in the center above the CTS unit or two 46 inches displays when they are located on both sides of
the unit, as shown in
If you want to install auxiliary displays using ceiling mounts, use the measurements provided in
Figure 2-12
Cisco does not provide the ceiling mounts. Make sure that the ceiling can structurally support the mount
Caution
and that the installation complies with all applicable building codes and regulations.
Figure 2-12
Auxiliary Display Considerations
2
1
Table 2-21
Callout
1
2
3
OL-27038-01
Figure
2-12.
through
Figure 2-14
and
3
Callouts for
Figure 2-12
Description
Height for a side mounted position is 64" (1.63 m) from floor.
Distance from the ceiling varies depending on ceiling height. Check the
height of the room prior to additional display selection and installation.
The TX system is 5'6" (1.68 meters) high, and the reflector wall is 7'
(2.13 meters) high.
The lateral position for a side-mounted display is 10'6" (3.20 cm) from
the center of TX9200.
These measurements for side displays are based on 46-inch
Note
displays. For wider displays, move the displays farther away from
the midpoint of the system.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Auxiliary Display Considerations For the TX9200
Table 2-21
through
Table 2-23
to mount them.
3
2-23
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
