Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 270

Assembling an 8-Seat Second Row For a 14-Seat TX9200
Connect the power cables, and route and connect the power and Ethernet cables, by completing the
Step 20
following steps:
a.
b.
c.
d.
e.
For additional cabling information, see
Figure 13-20
Note
10-, 14-, or 18-seat system.
Key Part Description
1 Table leg side panel assembly, second
row left
2 Table leg side panel assembly, second
row right
3 Table leg side panel assembly, second
row far right
4
Table leg side panel assembly, second
row far left
5
Velcro straps
6
Power jumper cables
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
13-24
Attach jumper cables to the second row PDUs and route the cables to the right (the side nearest table
leg 800-37778-xx). These cables are shown in blue in
If required, use two jumper cables to connect the power outlets for table legs 800-37776-xx,
800-37777-xx, and 800-37781-xx. You connect a total of six jumper cables.
Route the cables for the second row table as shown in
Place the power cables in the bottom row of the cable trays.
•
• Place the Ethernet cables in the middle row of the cable trays.
Neatly bundle any excess cable and secure the cables with Velcro straps (callout 1).
Use Velcro straps (callout 1) to cleanly route the cables.
Attach the table leg side panel assemblies (callouts 2, 3, 5, and 6).
Level the table assembly using a laser level and the diamond marks on the sides of the legs as a
reference point.
shows a second row with six sections; however, this assembly step is the same for either a
Part Number
700-37182-xx
Kit # 800-37777-xx
Subkit # 69-2314-xx
700-37183-xx
Kit # 800-37777-xx
Subkit # 69-2314-xx
700-37722-xx
Kit # 800-37778-xx
Subkit # 69-2314-xx
700-37721-xx
Kit # 800-37776-xx
Subkit # 69-2314-xx
52-0499-xx
Kit # 69-2403-xx
Subkit # 53-3789-xx
37-0833-xx
Kit # 69-2351-xx
Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
Figure
Figure
Chapter 10, "Connecting and Routing the Cables."
Qty
4
4
1
1
70
6
13-20.
13-20.
Ctn Notes
51
51
51
51
6 Not shown in
Figure 13-20
48 Not shown in
Figure 13-20
OL-27038-01