Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 75

Chapter 4 Installing And Performing Initial Leveling of the Main Display Structure
Attach the tie bars to the left and right display structure by completing the following steps:
Step 6
a.
b.
c.
Do not fully tighten the screws until you perform final leveling of the entire display structure.
Note
Key Part Description
1 M8 x 16mm pan head screws
2 M8 x 35mm pan head screws
Figure 4-9 Attaching the Left and Right Display Structures to the Lower Tie Bar (1 of 2)
OL-27038-01
Place the left and right structures in their approximate position.
Lift the center structure (with the bottom tie bars attached) over each side structure using the dowel
pins on the left and right tie bars to aid in aligning the structures.
Screw the top plate down using M8x16mm screws.
Part/Kit Number
48-3012-01
Kit #69-2365-xx
48-3008-01
Kit #69-2366-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Qty Ctn
4 6
8 6
Installing and Leveling the Display Structure
Notes
4-11