Replacing The Hard Drive - Avaya S8500 Job Aid

Job Aid: Replacing the Hard Drive on the Avaya S8500 Media Server— R2.2 or Later
Final tasks for replacing a hard drive in an S8500 Media Server 5 of 5
9
Task
40 Set a timeout value
41 Set the loader watchdog
timeout
42 Log off and disconnect from
the RSA/SAMP

Replacing the hard drive

Depending on the S8500 media server model, select one of the following procedures:
Replacing the hard drive in the S8500B media server
●
Replacing the hard drive in the S8500 media server
●
!
CAUTION:
Wear an antistatic wrist ground strap whenever handling components such as the
CAUTION:
hard drive of an Avaya S8500 Media Server. Connect the strap to an approved
ground, such as an unpainted metal surface. Also, place the hard drive on an
antistatic mat that is similarly grounded. Do not place the new or the old drive on
a bare surface.
Replacing the hard drive in the S8500B media server
This procedure contains the following sections:
Removing the hard drive from the S8500B media server
●
Installing the hard drive
●
8 Replacing the Hard Drive on the Avaya 8500 Media Server
Description
In the Welcome screen, in the Inactive session timeout
value field, select no timeout and click Continue. The no
timeout value allows 60 minutes of inactivity before
disconnecting.
Under ASM Control, click System Settings. Scroll down to
the Server Timeouts section, and in the Loader watchdog
field, select 5.0 (minutes) and click Save.
Click Log Off. Once you are logged off, disconnect from the
services port on the RSA/SAMP.
5 of 5