Item
7
8
9
10
11
12
Replacing the IDE hard drive
Introduction
The hard drive rests lengthwise along the backplane side of the server. The hard drive bracket
is secured in place by five screws: two on the backplane edge, two through the motherboard,
and one through the bottom edge of the stiffener.
Note:
The 3.5 inch hard drive is no longer available. A 2.5 inch drive must be ordered as a
replacement. If you are replacing a 3.5 inch hard drive with a new 2.5 inch hard drive, you
must have the NTRH9107E5 hard drive replacement kit. The kit description and assembly
instructions are described later in this section. The 2.5 inch hard drive is ordered separately.
See the Avaya price book for particulars.
Equipment required
The following equipment is required for this procedure:
• antistatic wrist strap
• Phillips No. 1 screwdriver
Avaya CallPilot® 201i Server Maintenance and Diagnostics
Hard drive mounting bracket
Software feature key (dongle)
Faceplate
Monitor connector
Mouse connector
Keyboard connector
Replacing the IDE hard drive
Description
December 2010
97